Getting Started
27
Turning On/Off the Display
Press the power button when the system is on to turn off the display and put the system in standby
mode.
When the system is in standby mode, press the power button once to wake up the system and turn
the display on.
Removing and Securing Port Covers
The tablet's connectors are covered and protected by sealed port covers to avoid damage or dust
intrusion to the connectors.
When using the connectors, you need to remove the port covers. To remove the port cover, pull it
outward and then flip it away from the connectors.
NOTE:
Do not use excessive force when removing the port covers.
When the connectors are not in use, it is strongly suggested that you close the port covers
securely. To properly close the port cover, follow the instructions below:
1. Press down the port cover on the end to engage it to the tablet.
2. Slide the port cover toward the port cover hinge, and then slide it in the reverse direction until it
is locked in place, as shown in the image below.
NOTE:
Make sure the port covers are closed tightly to prevent water or dust from entering the tablet and causing
damage.
Summary of Contents for CAXA0
Page 1: ...CAXA0 Rugged Tablet User Manual...
Page 39: ...Operating Your Tablet 39 2 Press the left and right hooks inward...
Page 40: ...CAXA0 Rugged Tablet User Manual 40 3 The upper cover automatically pops up...
Page 41: ...Operating Your Tablet 41 4 Take off the tablet from the mounting station...
