SMA-X8I, REV-SA03 User
’s Manual
4 SMA-
X8I, REV-SA03
User’s Manual
1.
Getting Started
1.1 Safety Precautions
Warning!
Always completely disconnect the power cord from your
chassis whenever you work with the hardware. Do not
make connections while the power is on. Sensitive
electronic components can be damaged by sudden power
surges. Only experienced electronics personnel should
open the PC chassis.
Caution!
Always ground yourself to remove any static charge before
touching the CPU card. Modern electronic devices are very
sensitive to static electric charges. As a safety precaution,
use a grounding wrist strap at all times. Place all electronic
components in a static-dissipative surface or static-shielded
bag when they are not in the chassis.
Always note
that improper disassembling action could cause damage to the
motherboard. We suggest not removing the heatsink without correct
instructions in any circumstance. If you really have to do this, please contact
us for further support.
1.2 Packing List
Before you begin installing your single board, please make sure that the
following materials have been shipped:
1 x SMA-X8I Risc Module
1 x REV-SA03 Carrier board
Summary of Contents for REV-SA03
Page 13: ...User s Manual SMA X8I REV SA03 User s Manual 13 2 Hardware Configuration ...
Page 26: ...SMA X8I REV SA03 User s Manual 26 SMA X8I REV SA03 User s Manual 3 Mechanical Drawing ...
Page 27: ...User s Manual SMA X8I REV SA03 User s Manual 27 SMA X8I Unit mm ...
Page 28: ...SMA X8I REV SA03 User s Manual 28 SMA X8I REV SA03 User s Manual REV SA03 Unit mm ...
