Service and maintenance
Avant 850
100
.
Installing of service support and frame
lock
Installing boom service support:
Whenever access to area below near a lifted boom is
needed, install the service support to the hydraulic
cylinder of the boom.
A red service support is stored on the boom, near the
quick coupling plate.
1.
Loosen the manual nuts (2) holding the service
support (1). Remove the service support, its
securing bolt (3), and one of the manual nuts
2.
Lift the loader boom up. Shut down the loader
3.
Place the service support on the piston rod of
the levelling cylinder, as shown in the picture
below
4.
Secure the service support in its place with its
securing bolt and manual nut
5.
While seated on the driver's seat, keep the
engine off, and lower the boom until it rests on
the service support
Service support is stored at the front storage
compartment
Service support in place
Frame lock:
A red frame lock bar is stored under the operator's
cab.
This lock bar is intended to lock the articulated frame
to make the loader frame stay straight during e.g.
lifting or transportation.
The holes for the frame lock bar are on the left side
of the loader, below the access step.
1.
Slide the hook type end of the bar through a
hole on the rear frame of the loader.
2.
Turn the bar towards the front hole. The other
end should remain locked in the hole on the
rear frame.
3.
Align the holed end of the bar and the frames
by turning the steering wheel. This can be
done without starting the loader.
4.
Once aligned, slide the bar and lock with its
cotter pin.
Summary of Contents for Avant 850
Page 1: ...English Operator s Manual 2020 A441827EN 2020 1 2020 www avanttecno com...
Page 128: ...Avant 850 128...
Page 132: ...Avant 850 132 Notes...
Page 133: ...Avant 850 133 Notes...
