Avant 850
Lift capacity
43
.
Tipping load - Load diagram
Load diagram
With the diagram the load handling capability of the
loader can be evaluated, according to the distance
between the centre of gravity of the load and the
front axle of the loader. The diagram represents the
forward stability only,
it does not refer to maximum
available lift force.
The load diagram below shows the tipping loads on a
level surface:
a) Tipping load with the loader frame in straight
position.
b) Tipping load with the loader frame in
maximum articulation.
ROC (Rate operating capacity), defined as
60 % of tipping load for pallet forks.
WARNING
Avoid overloading the loader -
Know the load and the lifting
capacity of the loader.
Heavy
load can cause the loader to tip
over. The diagram is valid only on
firm and level ground, with the
conditions listed on page 38. The
load can exceed tipping load and
loader can tip over when you move
the loader boom to another
position.
.
Load diagram 850
How to read the load diagram
a
Tipping load with the loader frame in straight
position.
b
Tipping load with the loader frame in maximum
articulation.
ROC (Rated operating capacity), defined as 60
% of tipping load for pallet forks.
The tipping load chart describes only the stability
of the loader to forward direction - it does not
refer to maximum available lift force.
The tipping load lines in the chart extend beyond the
hydraulic lift capacity of the loader.
Example:
If the centre of gravity of the load is 970
mm in front of the front axle (500 mm from the pallet
forks, forks at ground level)
Tipping load would be about 2000 kg when lifting
from ground surface level, with a driver weighing
75 kg, and with the articulated frame in straight
position (line
a
in load diagram).
This means that in terms of tipping load, a pallet
with a total weight of up to about 2000 kg can be
lifted just off the ground, but it can't be lifted
higher, as the loader would tip over. However,
the hydraulic lifting capacity of the is less than
the tipping load when lifting loads just off the
ground.
When the boom is lifted to horizontal position,
the tipping load is reduced to about 1490 kg (line
a
in load diagram, the horizontal distance of the
center of the load on forks increases to about
1670 mm).
Summary of Contents for Avant 850
Page 1: ...English Operator s Manual 2020 A441827EN 2020 1 2020 www avanttecno com...
Page 128: ...Avant 850 128...
Page 132: ...Avant 850 132 Notes...
Page 133: ...Avant 850 133 Notes...
