Controls and options of the Loader
Avant 850
70
Air recirculation
For faster warm up of the loader, the cab is equipped
with an air recirculation system. When the hatch is
opened the heating system pulls air from the cab and
circulates it back into the cab through the nozzles.
This way the cab warms up quicker in cold weather.
The system can also be used for cooling.
If used for heating, switch off the
air circulation as soon as the
temperature in the cab is sufficient,
otherwise the cab keeps warming
up and moisture starts to condense
on the windows.
WARNING
Risk of serious illness from
prolonged exposure to
crystalline silica -
Do not
operate the loader without a cab
air filter cartridge in place.
To
reduce exposure from silica dust
always keep the cab air filter in
good condition. Keep the cab door
and windows closed when
operating at area where dust is
present. Use a breathing mask
when at risk of being exposed to
silica or other types of dust. Using
the ventilation system without the
filter in place increases the level of
dust inside the cab.
Defrosting/De-misting:
Turn heater fan to position 4 (high speed)
Set temperature to warmest possible
Switch on A/C (if fitted). The air conditioning will
dry air
Direct front vents towards the windows. Close
other vents
Keep air recirculation hatch closed. Using the air
recirculation will increase moisture in the cabin
CAUTION
Risk of collision - Never drive
the loader when the visibility is
poor.
Do not drive unless basic
visibility in all directions is
achieved. Allow the loader to warm
up properly.
Air conditioning (Option for cab GT)
Cab GT can be equipped, as an option, with air
conditioning (cooling). The switch for A/C is located
on the left side of the driver's seat.
When the A/C system is installed, its condenser is
located rear of the cab. The condenser must be kept
clean and clear of debris. The installation location of
the condenser can't be changed.
During winter, switch on the air conditioning for a few
minutes weekly in order to lubricate A/C circuit and to
maintain the compressor in good condition.
The A/C will work only while the
fan is switched on.
Summary of Contents for Avant 850
Page 1: ...English Operator s Manual 2020 A441827EN 2020 1 2020 www avanttecno com...
Page 128: ...Avant 850 128...
Page 132: ...Avant 850 132 Notes...
Page 133: ...Avant 850 133 Notes...
