Avant 850
Service and maintenance
111
9.
Check hydraulic oil level
Check the level of hydraulic oil with the dipstick of
the filler cap. Remove the front panel to access the
filler. Keep the loader boom completely lowered.
Check level of hydraulic oil especially after using a
new attachment that drains hydraulic oil from the
loader as the hydraulic system of the attachment fills
up. Check also if you have noticed a leak of hydraulic
oil.
Oil level should be near the lower marker on the
dipstick (1) when the hydraulic oil is cold.
Tighten the dipstick on its threads for measurement.
Refill when necessary, but never exceed the upper
limit mark (2). Doing so can cause oil to overflow
when lowering the boom.
1.
Target marker. Fill to this
mark when hydraulic
system is
cold
.
The area highlighted in
the adjacent figure
shows approximately the
acceptable level.
2.
The second mark on the
dipstick indicates max
level of hydraulic oil. Oil
can reach this level
when hydraulic system
is
hot
.
Never overfill the hydraulic oil tank. Oil can flow over,
or foam inside tank.
There is a breather filter inside the dipstick cap which
must be cleaned or changed once a year.
.
10.
Check engine oil level
Check the engine oil level with the dipstick. To get
correct result with the dipstick:
1.
Park the loader on level surface
2.
Allow the engine to cool down and the oil level
settle before you check the oil level
3.
Push the dipstick all the way in to get the
correct reading.
If the engine oil level is not in between the markers
on the dipstick, add a small amount of correct type of
motor oil to the engine. Use only high quality engine
oil that is approved for your loader model. For more
information about oil see page 35.
Allow oil level to settle for a moment after adding oil,
and check level again. Do not add too much oil to the
engine, as it can damage the engine.
Avant 850:
Engine oil dipstick and the filler opening are
accessible through a hatch on the storage
compartment in the engine bay.
Never add too much oil in the
engine - severe engine damage
may result. Excessive oil may also
cause heavy emissions and thick
exhaust smoke. In case of overfill,
drain some oil from the engine.
Summary of Contents for Avant 850
Page 1: ...English Operator s Manual 2020 A441827EN 2020 1 2020 www avanttecno com...
Page 128: ...Avant 850 128...
Page 132: ...Avant 850 132 Notes...
Page 133: ...Avant 850 133 Notes...
