Operating instructions
Avant 850
74
WARNING
Risk of injury to bystanders -
Avoid unintended movements of
the attachment:
If the auxiliary hydraulics is
switched on during starting
and there is a hydraulically
operated attachment on the
machine, the attachment can
move suddenly and cause a
dangerous situation.
Make sure that the auxiliary
hydraulics control lever is in
neutral position during starting.
Do not actuate the auxiliary
hydraulics control buttons on
the joystick (if fitted) when
starting.
.
..
Make sure that all the warning
lights on the control panel are off
when the engine is running. If the
engine does not start after a few
attempts, or runs poorly, See
troubleshoot 129.
After starting:
Allow the engine to warm up and
engine oil to circulate in the engine
for a moment before loading the
engine or increasing the engine
rpm.
.
Stopping the engine (Safe stopping
procedure)
1.
Lower the boom completely down. Place
attachment firmly on the ground, engage
parking brake, stop the attachment (move
auxiliary hydraulics control lever to neutral
position, see page 50), set engine rpm to idle.
NOTE:
Allow the loader to idle for a moment
before stopping the engine, especially after
heavy load on the engine.
2.
Stop the engine by turning the ignition key to
the OFF position (to the left)
3.
Release auxiliary hydraulics pressure (see
page 89)
4.
Prevent unauthorised use of the loader. Take
off the ignition switch and turn the power off
with the battery disconnect switch.
Avoid unnecessary idling of the
engine. Idling the loader causes
internal wear of the engine,
emissions, and clogging of the
exhaust and emission control
systems. The diesel engines are
not intended to be left running at
idle speed over long periods of
time. Shut down the engine
whenever leaving the driver's seat.
.
Stop if you notice any of the following:
Stop the engine as soon as
possible, if any of the following
symptoms is observed. Find out
the cause before restarting.
The oil pressure warning light, or malfunction
indication light turns on during operation.
Engine rpm increases and/or decreases
suddenly by itself, without touching the
throttle lever.
A sudden and unusual noise is heard.
Sudden increase in engine vibration.
The colour of the exhaust fumes suddenly
darkens or turns white.
Summary of Contents for Avant 850
Page 1: ...English Operator s Manual 2020 A441827EN 2020 1 2020 www avanttecno com...
Page 128: ...Avant 850 128...
Page 132: ...Avant 850 132 Notes...
Page 133: ...Avant 850 133 Notes...
