17
700 Series
Operating instructions
17
Suspension seat
The optional suspension seat is equipped with a seat
belt and has the following adjustments:
1. Suspension adjustment
by turning the knob counterclockwise suspension
gets harder, by turning it clockwise the
suspension gets softer
2. Angle of the back rest
the angle of the back rest can be adjusted by
pulling the lever
3. Seat position
the distance of the seat from the steering wheel
can be adjusted with the lever which is located
under the front edge of the seat
4. Arm rest angle adjustment
the angle of the arm rest can be adjusted by
turning the roller under the arm rest
Suspension seat can be equipped with a seat belt.
Seat heater
The suspension seat is
equipped with an electric seat
heater. Seat heater switch
(15) and indicator are
located on the dashboard.
Location of battery disconnect switch
The loader is equipped with
a battery disconnect switch.
The switch is located in the
rear of the machine, on the
right side (see picture).
Battery disconnect switch
cuts the current between
battery and the rest of the electric system. Always
switch off main current when the loader is not used
for a longer period of time, or when servicing the
machine. Switch off the main current in order that
the battery doesnt get empty.
Boom self levelling (option)
Self levelling system keeps the
position of the attachment
the same in relation to the
ground, regardless of the
position of the boom.
Self levelling is hydraulic: there
is a levelling cylinder on the
left side of the boom which
follows the movements of the
bucket tilt cylinder and keeps
the attachment level.
Self levelling is disabled when
the boom floating is switched
on.
Boom floating (option)
The floating system releases the lift cylinder, so that
the boom floats upwards from the position where it
is when boom floating is switched on, allowing the
attachment to follow the contours of the terrain.
1. Lower the boom down
2. Switch on the floating with
rocker switch no.
3. Boom floating indicator on
the dashboard
lights up
When boom floating is being
used, it is possible that air gets
in the hydraulic system. This can lead to inaccurate
boom movements and the boom can give in. Therefore
the boom and attachment coupling plate should always
be moved to extreme end positions after switching
off boom floating. Use boom floating only when
necessary.
Telescopic boom (option)
Telescopic boom is operated with the control lever
no. 8 on the control panel (see page 15).
Length of the telescope is 600 mm and additional
lifting height is 485 mm.
1
2
3
4
17
15
https://tractormanualz.com
