Operating instructions
Joystick (option)
The loader can be equipped,
as an option, with a joystick,
where the operation of
auxiliary hydraulics and
telescopic boom is electric.
1. Auxiliary hydraulics
push the buttons to engage
and disengage auxiliary
hydraulics. The red
switch directs hydraulic
flow to the pressure 1
coupler.
2. Telescopic boom
with the rocker switch the
telescopic boom can be
operated steplessly
(extension- retraction).
Speed of the telescoping
function depends on the
position of the pump
selection lever.
Engine block heater (option)
The loader can be equipped, as an option, with an
engine block heater. Engine
block heater outlet is on the
right side in the rear of the
machine.
Use the block
heater max. 30
minutes at a time.
Trailer coupling (option)
The loader can be equipped,
as an option, with a trailer
coupling. It is equipped with
a 50 mm ball coupling and
mounts either directly on the
rear bumper or on the extra
back weight.
Max. allowed vertical load of the trailer coupling is
6900 N, max. towing load is 6000 N.
Make sure that the weight on the trailer is
distributed correctly so that the trailer cannot
cause an upward lifting force on the trailer
coupling
Extra weights (option)
The loader can be equipped with extra counterweights
that are mounted on the rear bumper. Max. amount
of extra weights (31 kg/pcs) is 4 pcs. If the machine
is fitted with an extra weight with trailer coupling,
max. amount of extra weights is 2 pcs. Loader can be
equipped with side weights 180 kg (A49063).
Drive circuit release switch (option)
The switch no. 16, LOCK,
controls a valve, which is used
to divert the oil flow between
left and right side hydraulic
motors, and this affects the
pulling force.
LOCK OFF:
In this mode, the hydraulic oil flows in
series from motor to motor. The wheels will roll more
freely and the loader leaves less tire marks on soft
surfaces.
LOCK ON:
In this mode the hydraulic oil flows in
parallel between the hydraulic motors in each side,
similar to a differential lock in operation. This improves
the towing capability of the loader.
If the loader is not equipped with a drive circuit release
valve, the system will function as in lock on mode.
Anti slip valve (option)
AVANT 745
: The valve positively diverts oil flow
between right and left side hydraulic motors and
improves traction on slippery and uneven surfaces.
The function of the anti slip valve is connected to the
drive circuit release switch:
LOCK ON:
Anti slip valve in operation. Best traction
is achieved by using sufficient engine revs and by
pressing properly on the drive pedal.
LOCK OFF:
Drive circuit
released anti slip valve
diverts the oil flow between
the front hydraulic motors
only, not the rear hydraulic
motors.
AVANT 750
: Anti slip valve
is engaged by pressing on the
switch on the joystick.
Work light kit (option)
The loader can be equipped with extra work lights,
making it easier to work in low light. The lights are
operated with the switch on the control panel (see
page 14).
16
1
2
18
700 Series
https://tractormanualz.com
