700 Series
Operating instructions
19
Tilt adapter (option)
The hydraulic tilt adapter
mounts between the
attachment and the
attachment coupling plate. It
allows the driver to tilt the
attachment sideways 12,5
degrees to both directions
from the drivers seat. Tilt
adapter is intended mainly for
non-hydraulic attachments,
but with the optional double acting extra auxiliary
hydraulics outlet in the front (A35492) it is possible
to mount a hydraulically operated attachment (e.g. a
4 in 1 bucket) at the same time. Tilt adapter is operated
with the auxiliary hydraulics control lever (no. 7, page
15).
Extra auxiliary hydraulics outlets, front
and rear (option)
In addition to the standard auxiliary hydraulics outlet,
the loader can be equipped with a double acting extra
outlet. The extra hydraulic outlet can be fitted either
to the front of the loader or to the rear, and the
couplers are conventional type quick couplers. The
installed extra outlet is selected with the rocker switch
on the dashboard (see page 13) and controlled with
the auxiliary hydraulics control lever no. 7 (see page
15).
The loader can be equipped with either the rear
hydraulics outlet or with the extra front outlet but
not with both.
1. Extra auxiliary hydraulics
in the front
Quick couplers are
located under the multi
connector
2. Quick couplers in the rear
Quick couplers are
located on top of the
radiator.
Double acting outlet
Single acting outlet
Drive speed range selection switch (750)
AVANT 750 is equipped with two
speed drive motors. Drive speed
range can be selected with the switch
no. 13 on the control panel right (see
page 10). With lower speed range
(switch in "turtle" position) drive speed
is 0-12 km/h, with higher speed range
(switch in "rabbit" position) drive
speed is 0-25 km/h with 29 tyres and
0-22 km/h with 26 tyres.
When driving backward at higher speed range the
pulling force is about 50 % of the pulling force forward.
At lower speed pulling force forward and backward
is the same.
Pulling force at lower speed is twice the pulling force
at higher speed. Higher speed range is intended for
longer travels where pulling force is not necessary.
ATTENTION!
Do not change the drive speed range
while driving with a higher speed. Always stop the
machine first or slow down the speed before switching
on higher or lower speed. Be careful when driving at
higher speed range. Do not turn the machine with a
high travel speed.
Parking brake switch (750)
AVANT 750 is equipped with a
hydraulic parking brake. It locks the
front wheels. Parking brake is operated
with the switch no. 14 on the control
panel right (see page 10). The switch
has two indicator lights: green indicator
is on when parking brake is released,
red indicator is on when parking brake
is engaged.
Parking brake engages automatically when the engine
is stopped. The brake can be released only when the
engine is running and there is hydraulic pressure in
the system.
ATTENTION!
Never engage the parking brake when
the machine is moving. If the parking brake is engaged
when the machine is moving the brake plates in the
front drive motors will be damaged. Always stop the
machine before engaging the brake.
Snow chains (option)
The loader can be equipped with snow chains, following
tyre size:
26 x 12.00-12 snow chain part no. 64973
320/60-12
snow chain part no. 65603
Pressure 1
Pressure 2
Pressure 2
Pressure 1
Pressure
Tank line
https://tractormanualz.com
