23 (36)
6.5
Adjusting the cutting height
The cutting height can be adjusted by using the plastic sleeves on the vertical axles of the support wheels.
The mower does not need to be disconnected from the loader while adjusting the height. To adjust the height:
1.
Lift the attachment slightly off the ground with the loader and shut
down the engine.
2.
Remove the cotter pin from the vertical axle of the bearing wheel.
Pull the wheel off its holder.
3.
Move some plastic sleeves from above the bracket to below it or
vice versa, depending on whether you wish to raise or lower the
mower.
4.
Push the axle back in through the bracket and reinstall the cotter
pin.
5.
Repeat steps 2–4 for each wheel. Ensure that all wheels are
adjusted to the same height.
There are two thicknesses of plastic sleeves (10 &
20 mm) for more accurate adjustment of the
operating height. Adjust all wheels to the same
height.
Always leave at least one plastic sleeve on the vertical axle above and below the frame
bracket to ensure the correct operation of the bearings.
Summary of Contents for A35973
Page 2: ...Collecting Lawn Mower 1200 2020 2 ...
Page 36: ......