23 (28)
7.2
Cleaning the attachment
Clean the rotary hoe as soon as possible after use, since this makes cleaning easier. Right after use, lift the
rotary hoe off the ground and rotate it on the air, starting slowly, to remove the largest lumps of soil from the
blades. Do not strike the hoe against the ground. A pressure washer and mild detergent can be used for
cleaning. Do not use strong solvents, and do not spray directly at the hydraulic components, or at the labels
on the attachment. After washing lubricate the lubrication points.
Clean the attachment regularly to prevent accumulation of dirt which is more difficult to remove.
WARNING
Entanglement hazard - Risk of entanglement also persists during maintenance.
Always follow the safe stopping procedure before any cleaning, maintenance, or service
operation.
7.3
Lubrication
The rotary hoe has four lubrication points, located at the ends of the flail roller, at the attachment gear and at
end of the blade shaft.
A small amount of lubricant should be added to the lubrication points at the bearings regularly. Correct
lubrication interval depends heavily on operating conditions but lubricant must be added at least after every 5-
10 hours of use.
Clean the end of the nipple before greasing and add only a small amount of grease at a time. The lubrication
nipple is a standard R1/8" nipple. Replace it, if damaged.
Lubricant must be added approximately every 5 to 10 operating hours. Clean the end of
the nipple before greasing. Only add the grease amount of a couple of grease press
pushes at a time.
7.4
Inspection of metal structures
Also the metal structures of the attachment must be inspected regularly. Check visually for damages and
inspect the quick attach brackets and their surrounding area carefully. The attachment must not be used if it is
deformed, cracked, or torn.
Welding repairs are only allowed to be carried out by professional welders. When welding, only methods and
additives suited for steel used in attachment must be used. For more information about repairs contact your
nearest service point.
