16 (22)
6.3
Adjusting the operating depth
The operating depth can be adjusted by adjusting the support wheels of the aerator. Wheels are adjusted by
using the plastic sleeves on the vertical axles of the wheels. The attachment does not need to be
disconnected from the loader while adjusting the height. To adjust the height:
1.
Lift the attachment slightly off the ground with the loader
and shut down the engine.
About 20 cm height from the ground is sufficient.
2.
Remove the cotter pin from the vertical axle of the
bearing wheel. Pull the wheel off its holder.
3.
Move some plastic sleeves from above the bracket to
below it or vice versa, depending on whether you wish
to raise or lower the attachment.
4.
Push the axle back in through the bracket and reinstall
the cotter pin.
5.
Repeat steps 2–4 for each wheel. Ensure that all
wheels are adjusted to the same height.
There are two thicknesses of plastic sleeves (10 & 20 mm) for more accurate adjustment
of the operating height. Adjust all wheels to the same height.
6.4
Support legs
The Aerator is equipped with four support legs. Lower the attachment on the legs during maintenance, and
keep the legs folded up while operating the Aerator. The legs are spring balanced.
