20 (24)
7.
Maintenance and Service
The attachment has been designed to be as maintenance free as possible. Continuous maintenance includes
regular cleaning and lubrication, and monitoring the condition of the attachment. Because of the crushing
hazard caused by lowering machine parts, all maintenance work must be done when moving parts have been
lowered down completely and the attachment is lowered flat against the ground.
DANGER
Risk of crushing - Never go under lifted attachment.
Make sure the attachment is
properly supported during all maintenance work. Never go under a lifted attachment. The
loader boom may lower unexpectedly during maintenance causing serious injuries from
crushing or impact even when the loader engine is not running. All maintenance and
service must be performed when the attachment has been lowered down to a safe
position.
WARNING
Risk of crushing - The grapple may lower by itself as
a result of a fault or use or service mistake causing
serious injuries.
All maintenance procedures must be
performed when the grapple has been lowered down
completely.
7.1
Inspection of hydraulic components
Check the condition of the hydraulic hoses and components when the engine has been turned off, system has
cooled down, and the pressure has been relieved. Do not use the equipment, if you have discovered a leak in
the hydraulic system of the attachment or the loader. Leaking hydraulic fluid may penetrate skin and cause
serious injuries. Seek medical attention immediately in case hydraulic fluid penetrates the skin. Wash any part
of body that has been in contact with hydraulic oil carefully with water and soap. Hydraulic fluid is also harmful
to the environment and any leak to the environment must be prevented. Repair all leaks immediately after
detecting them; a small leak can quickly grow into a big one. Operate the attachment only with type of
hydraulic oil that is accepted for use in Avant loaders.
DANGER
Risk of high pressure fluid injection
through skin - Release residual pressure
before maintenance.
Never handle hydraulic
components when the hydraulic system is
pressurised, since a fitting may break or
become loose and the released oil may cause
serious injuries. Do not use the equipment, if
you have discovered a fault in the hydraulic
system.
Summary of Contents for A440586
Page 2: ...XL Silage grab 2020 1 ...
Page 24: ......
