6(18)
5.1.
Mounting kit A48130
These instructions for the mounting kit A48130 are applicable to all 400-, 600-, and 700-series loaders, as
well as to 500-series loaders manufactured in 2008 or later. Contact your AVANT dealer if using the backhoe
with other loader models.
5.1.1.
Contents of the mounting kit
The mounting kit contains the following
loader dependent components:
1. Supporting bracket kit to be
mounted on the loader, inc. pins
and locking cotter pins
2. Control valve
unit mounting
bracket, its adapter and mounting
supplies
3. Adapters
(2
pieces)
for
attachment
hydraulic
locking,
bolts, washers and nuts
5.1.2.
Mounting the lower adapter brackets for hydraulic locking
The backhoes are hydraulically locked to the front frame of the
loader by the brackets, which are turned against the underside
of the loader. Before putting the backhoe into service, the lower
adapter brackets must be mounted.
The locking adapters (see figures on the right and below) are
mounted to below the quick attach plate. The brackets should
be mounted to the outer side of the backhoe frame brackets.
The convex edge of the bracket should face upwards.
Locking adapter’s mounting holes:
1: mounting holes for 400-600-series loaders
2: mounting holes for 700-series loaders
Mount the lower adapter brackets with the provided M14 sized bolts and nyloc nuts. Use washers on both
the bolt and the nut side of the fixing.
