Avant e6
13
WARNING
Never pull a heavy load on the
loader from high level – e.g.
from truck, shelf etc. – risk of
tipping over!
If the load is too heavy when lifting
load from a high level, the loader
could tip forward when reversing
with the loader.
Never reverse and drag with the
loader before you make sure that
the loader can handle the load that
is being lifted. If you drag a load
from a shelf without lifting the load,
the loader could tip over when the
load is no longer supported by the
shelf.
When loading, always keep the
loader frame as straight as
possible.
.
Hazardous areas around the loader
Make sure that there are no persons in the danger
zone of the loader and the attachment. The safe
distance to other persons depends on the
attachment that is installed, and the type of work.
The danger zone of the loader covers the reach area
of the loader boom, the turning area and wheels on
both sides of the loader, and the front and rear areas
of the loader. Stop the loader and its attachment
immediately if there are other persons close to the
loader.
Always make sure that it is safe to reverse with the
loader. Never assume that bystanders will remain
where you last saw them; especially children are
often attracted to the moving equipment.
Pay attention to other machines and persons that are
moving in the area. When learning how to operate
the loader, drive on level ground at a clear, open
area.
When you leave the loader unattended, always
follow the safe stopping procedure that is described
in this manual. In particular, always lower the loader
boom completely down, or lower the attachment on
the ground. The loader is not designed to stay with
the loader boom and load lifted. Remove the key
from the ignition to prevent unauthorised use.
