Avant e6
49
Rear carrier
To use certain attachments, or carry extra loads at
the rear of the loader, a rear carrier is available.
DANGER
Risk of loss of control of the
loader - Never add too heavy
load on the rear.
Too heavy loads
or attachment at the rear of the
loader, especially if combined with
extra counterweights, can make
the front of the loader too light.
Front wheels can lose contact from
the ground. Ensure that loader is
loaded evenly. Remove
counterweights if necessary.
WARNING
Risk of shearing of hands or
fingers and impact - Unlocked or
improperly locked rear carrier
can swing.
Make sure both of the
locking pins of the rear carrier are
locked. Unlocked carrier can swing
in uncontrolled way, creating
hazards of impact, crushing, and
pinching between its linkage. If
attachment gets damaged because
of unlocked carrier, it can cause oil
spray and fire. Unlock the carrier in
controlled way and keep hands
clear from linkage.
Extra auxiliary hydraulics outlet
In addition to the standard auxiliary hydraulics outlet,
the loader can be equipped with a double acting
extra outlet. The couplers are conventional type
quick couplers.
Extra quick couplers located under the multi-
connector, at the front of the loader.
For instructions about use and how to connect or
disconnect the extra hydraulic couplings, see page
68.
You can operate either the hydraulic function
connected to the standard multiconnector, or the
function that is connected to the extra outlet.
Simultaneous use is not possible.
For the Avant e6, the extra hydraulics outlet can be
installed only to the front of the loader. Rear
hydraulics outlet is not available.
Reverse buzzer (option)
A reverse buzzer gives an audible signal whenever
reversing with the loader. This alarms others of an
approaching machine. Always ensure good visibility
from the driver's seat and look before you reverse
with the loader - the buzzer itself does not prevent
accidents.
