Avant e6
52
3.
ON
In this position:
The electric systems of the loader
are in normal operation mode.
The electric motors will run,
depending on use of the loader
and the active operating mode.
See more information on page
55.
All functions of the multi-function
display are available.
The automatic main switches of
the loader are ON.
Charging of the battery is
possible.
Emergency stop button
4.
The emergency stop button, reference 4 in the
the picture above, will shut down electric motors
of the loader when pushed.
The shut down state is close to the same as
when turning the ignition key to the position P.
In addition, the motor controllers are on and
give contactor fault on display.
To reset the emergency stop button, twist the
red button to release it back to original position.
Shut down the loader with the ignition key and
start again.
To start the loader:
1.
Perform daily checks (see Maintenance &
Service on page 83)
2.
Sit on the driver's seat, adjust seat, and fasten
seat belt
3.
Move the hand throttle lever to idle position
4.
Make sure that auxiliary hydraulics is switched
off (lever in neutral position), see page 39.
Do
not press on the drive pedals.
5.
Turn the ignition key to position ON
Automatic battery disconnect switch will be
switched on when ignition key is turned
The hydraulic pumps of the loader will not
operate if the ignition key is in position
P
After this the loader boom and drive pedals are in
operating mode. You can adjust the speed of the
pump of the boom and auxiliary hydraulics by turning
the Hand throttle lever for pump RPM control.
.
WARNING
Prevent unintended movements
of the loader.
Keep hands and
feet away from other controls of
the loader while starting.
WARNING
Misuse can be dangerous -
Prevent unauthorised use,
remove key.
Powerful loader and
its attachments can be dangerous
in the hands of an inexperienced
temporary operator. Take the key
with you to prevent unauthorised
use of the equipment.
To operate the auxiliary hydraulics
or drive pedals, you must be
seated on the driver's seat. Safety
system prevents use of hydraulic
systems, unless seated on the
seat. If you use an attachment that
is controlled from other position
than the driver's seat, see page
55.
.
Make sure there are no remaining
warning messages on the multi-
function display after start. If the
motors do not start after you have
turned the ignition switch to
position ON, see troubleshoot on
page 100.
.
