Tipping load with the loader
in max. articulation
Driver 75 kg
Max. load, ISO 14397-1
The loader in
max. articulation
Driver 75 kg
Distance from front axle mm
Load diagram
The lifting capacity of the loader is limited by the possibility of tipping around the front axle. The diagram
below shows the tipping loads and max. allowed loads in different loading situations on an even level surface
with the loader chassis in maximum articulation.
Description of the loader
12
R35
Transporting instructions and tie down points
Mount the articulation frame lock, shown on page 26,
on the machine during transports. Lower the boom
down and take off battery disconnect switch.
Remember to remove the frame lock after transport!
Tie down points are located on the rear frame on the
sides, and on the front frame close to the boom.
If absolutely necessary, the loader can be towed with
a rigid tow bar, by releasing the hydraulic drive circuit.
Max. allowed towing speed is 3 km/h, towing distance
max. 200 m.
When the drive circuit is released for towing,
the loader has no brakes. Before releasing
the drive circuit make sure that the parking
brake has been engaged, and release the
parking brake only after a rigid tow bar has
been connected.
The hydraulic drive circuit is released by turning the
screw on the right side of the variable displacement
drive pump about 3 rounds counterclockwise. Make
sure to put the drive circuit again in working order by
retightening the screw immediately after towing.
Contact Avant service for instructions if necessary.
The loader can be lifted by mounting appropriate
lifting slings on the ROPS frame. Before lifting, the
attachment and eventual extra weights must be
removed. Mount the frame lock on the machine. Make
sure that the lifting slings cannot move and that the
machine doesnt swing during lifting.
AVANT R35 load diagram
The diagrams can be interpreted as follows:
The diagrams show tipping load and max. load
with the load at different distances from the
front axle of the loader
Example: If the center of gravity of the load is
750 mm in front of the front axle, max. load is
about 820 kg with a driver weighing 75 kg.
NOTICE:
If the driver leaves the machine,
tipping and max. loads are reduced respectively.
Tipping load and max. load depend both on the
weight of the driver and the eventual extra
weights mounted on the loader.
Please note that the diagrams are based on the
machine operating on a level, even and firm
supporting ground. Loads should be significantly
reduced when operating on gradients and/or
on soft ground.
Read the safety instructions regarding handling
of heavier loads.