2/15/2013
2-PREPARATION &
INSTALLATION
INSTRUCTIONS
BEFORE USING YOUR WINE COOLER
Remove the exterior and interior packaging.
Check to be sure you have all of the following parts:
- 5 Shelves
- 1 Bottle/Can Basket
- 1 Instruction Manual
Before connecting the Wine Cooler to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION OF YOUR WINE COOLER
This appliance is designed for
free standing installation only and should not be recessed
or built-in.
Place your Wine Cooler on a floor that is strong enough to support it when it is fully loaded.
To level your Wine Cooler, adjust the front leveling leg at the bottom of the unit.
Allow 5 inches of space between the back and sides of the unit, which allows for proper air
circulation to cool the compressor.
Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform
properly.
Avoid locating the unit in moist areas.
Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning about power and/or grounding should be directed toward a Certified
Electrician or an authorized Product Service Center.
After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before
placing items in the compartment.
12
