Avanti CK302R, Instruction Manual

6



  Caution - Do not store items of interest to children in cabinets above a range or on the 

back guard of a range - children climbing on the range to reach items could be seriously 
injured. 



  Do Not Touch Surface Units or Areas Near Units - Surface units may be hot even 

though they are dark in color.  Areas near surface units may become hot enough to 
cause burns.  During and after use, do not touch or let clothing or other flammable 
materials contact surface units or areas near units until they have had sufficient time to 
cool.  Among these areas are the cook-top and surfaces facing the cook-top. 



  When Replacing Your Faucet – For safety reasons don not use a spout longer than 

150mm (6”). 

This Unit Is For Indoor Use Only 

-SAVE THESE INSTRUCTIONS- 

ELECTRICAL INSTALLATION INSTRUCTIONS 



Select a designated power source to be used specifically for this unit. 



Make sure that the A/C power and the designated circuit breaker is turned off. 



Attach and secure conduit to the knockout hole of the junction box. 



You must make sure that the conduit is long enough to reach from the unit junction box to the 
power source selected. 



Take off the cover plate from the junction box to connect the stripped end of the wires to the 
receptacles of the junction box.  Please follow the color codes of the wires to make sure that it is 
properly grounded. 



At the other end connect all wires to the power source and secure the conduit to the power 
receptacle, making sure that the colors of the wires are matched during the connection. 



Install or replace the cover plate to the junction box and turn ON the A/C from the source or circuit 
breaker. 



Then install the power cord of the refrigerator and the burners to the junction box of the unit. 

The electrical installation shown below must be performed by a qualified and licensed 
electrician, following all of the electrical codes and ordinances required by the State.