7
INSTALLATION INSTRUCTIONS
Before Using Your Appliance
•
Remove the exterior and interior packing.
•
Check to be sure you have all of the following parts:
•
3 Refrigerator Shelves
•
1 Left Middle Hinge
•
2 Vegetable Crispers
•
1 Left top Hinge Cover
•
1 Glass Crisper Cover
•
1 Left Middle Hinge
•
1 Instruction Manual
•
1 Left Door Open Stopper
For door reversal operation
•
1 Freezer Shelf
•
2 pieces of hole cover for
middle hinge
•
2 Freezer Door Bins
•
Before connecting the unit to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
Installation of Your Appliance
•
Place your refrigerator-freezer on a floor that is strong enough to support the refrigerator-
freezer when it is fully loaded. To level your refrigerator-freezer, adjust the leveling legs at the
bottom of unit.
•
Allow 5 inches of space between the back and sides of the unit, which allows the proper air
circulation to cool the compressor and condenser.
•
Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the refrigerator- freezer not
to perform properly.
•
Avoid locating the unit in moist areas.
•
Plug the unit into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Avanti Products service center.
Summary of Contents for FF18F0W
Page 30: ...30...
Page 32: ...32 FF18F0W FF18F1B FF18F3S 10222020 PRINTED IN CHINA...
