15
HOW TO USE THE TOP BURNERS
¬
GAS BURNERS
Gas flow to the burners is adjusted by turning the knobs which control the valves. Turning the knob so
that the indicator line points to the symbols printed on the panel achieves the following functions:
FIGURE 4 FIGURE 5
The maximum aperture position permits rapid boiling of liquids, whereas the minimum aperture
position allows simmer warming of food or maintaining boiling conditions of liquids.
To reduce the gas flow to minimum, rotate the knob further counter-clockwise to point the LO position.
Other intermediate operating adjustments can be achieved by positioning the indicator between the
maximum and minimum aperture positions, and never between the maximum aperture and
positions.
When the range is not being used, set the gas knobs to their
positions and also close the gas
shut-off valve placed on the main gas supply line.
¬
LIGHTING GAS BURNERS
In order to light the burner, you must:
1 – Turn the knob in an anti-clockwise direction up to the
position (maximum rate), push in and hold the knob
until the flame has been lit. The sparks produced by the lighter situated inside the relative burner will light the flame.
In the event that the local gas supply conditions makes it difficult to light the burner in
HI position, try again with the
knob in LO position.
2 – Adjust the gas valve to the desired position.
To re-light the burner, return the knob to the
position and repeat the operations for lighting.
Caution! The range becomes very hot during operation. Keep children well out
of reach.
= Closed valve
= Maximum rate
LO = Minimum rate
Summary of Contents for G2002CW
Page 2: ...2...
Page 57: ...57...
Page 58: ...58...
Page 60: ...60 Gas ranges Ver 3 0 02292012 PRINTED IN CHINA...
![Dacor RNR30NC[-C] Installation Instructions Manual preview](http://thumbs.mh-extra.com/thumbs/dacor/rnr30nc-c/rnr30nc-c_installation-instructions-manual_496435-01.webp)
