Additional Instructions:
Manual Operation (Open using the key).
• User will need to remove the key hole cover by placing a small pin or similar object in the hole below the
keyhole and key hole cover.
• Insert the emergency access key into the lock and turn clockwise to open the safe.
• While the door is open, change the batteries on the control panel or reset the passcode as described in the
“Resetting the Administrator Password” section.
Setting the Date, Time and Weekday:
• After the batteries have been installed, the LCD display will show “00-01-01” (Year-Month-Date) and “Week
1” (Monday) “00-00” (Time).
• Press the “*” to enter the programming mode, the “00” will begin to flash.
• Increase by pressing the “ 8 “ or Decrease by pressing the “ 0 “, when finished press the “#” to move to the
next item.
When finished programming, do not touch any key for approximately 7 seconds and the program will take
effect.
Tips:
For your convenience four (4) rubber feet are included with each safe and can be installed if needed.
Rubber Feet
Displaying the Audit Trail
1. Open the safe with the correct Administrator Password, after “open” displays on the LCD and vanishes,
press “8” to go backwards or “0” to go forward when the blue LCD background light is still on.
2. The LCD will display the current opening record with the following content: No 001 (opening count)
3. Pass 1 (personal password)
4. Pass 2 (administrator password)
5. The year – month- date time and day of the week when the safe was opened.
6. Press “0” before the displayed record disappears to move forward to the next record.
Avanti Products
Miami, FL 33172
In the event of service issues, please call the
Customer Hotline at 1-800 – 220 - 5570
