- 19 -
OPTIONS AND FEATURES
Manual Shut-Down
To manually shut down the AGDO perform the procedure as follows;
i.
press and hold Learn Button
ii.
whilst continuing to hold down the Learn Button, press and hold Run Button
iii.
AGDO will have entered Shut-Down Mode once the LED extinguishes
17.4
Solar Power
An optional Solar Power kit is available. Contact your AGDO dealer for further information.
Connect the Solar connection cable to the Control Board terminals “+CH-”
Important Note: The Battery Charger must be genuine Avanti brand
17.5
Warning Buzzer
An audible buzzer will;
a.
Single “beep” every 30 seconds to indicate that Battery Charger is not active.
b.
Double “beep” every 30 seconds to indicate that the Battery Charger is not active and that
remaining battery voltage is low therefore Shut- Down is imminent.
18.
Control Box
The Control Box houses most of the controls from which the AGDO may be adjusted and functionality
customized to suit individual requirements.
Most commonly used functionality controls are accessible from within the Courtesy Lamp Cover.
Less commonly used controls are accessible by removing both the Courtesy Lamp and Control Box Covers
to expose the Control Board.
Fig. 16
Removal and Replacement of Courtesy Lamp and Control Box Covers
Important Note: The control board and power supply contain high voltage components. Coming into
contact with these components may cause severe injury or death. Always switch of the AGDO and un
plug the power cord BEFORE removing the main Control Box cover. The Control Box cover should
only be removed buy a suitably qualified technician
Remove Courtesy Lamp and Control Box Covers as follows;
i.
Switch off AGDO at power point and unplug the power cord
ii.
open the Courtesy Lamp Cover by pulling it down at the finger recess point (Fig.17–A)
iii.
remove the lamp bulb (Fig.18–A) by first pushing in and then turning anti clockwise (same as
removing household light bulb)
Summary of Contents for SDO-21 DP
Page 1: ...1...
Page 2: ...2...
Page 8: ...8 ASSEMBLY INSTRUCTIONS Sectional Track Type Tip Up assembly depicted Fig 3 Fig 3A Fig 3B...
Page 28: ...28 NOTES...
