Avanti SDO-21 DP, Installation Instructions And User Manual

- 23 -

OPTIONS AND FEATURES 

24.

LED Indicator



The LED Indicator (Fig.18-C) is located under the Courtesy Lamp Cover and serves to indicate the 
functions as described in the following tables; 

Green LED – Transformer and Battery Powered AGDO 



Provides visual indication of functionality sequences as described in the following table; 

Display 

     Indicator 

Glow Solid  

Reached close limit position. 

Slow Flash  

Reached open limit position. 

Medium Flash    

Learning or deleting Hand Transmitter codes 

Quick Flash (A Mode)    

Learning new drive force parameters 

Quick Flash (M Mode)   

Force adjust mode activated 

Sleep 

Mode 

   Intermittent 

Flash 

Red LED – Battery Powered AGDO only. 



Provides visual indication of functionality sequence as described in the following table; 

 Display 

     Indicator 

 Glows 

Solid 

   Battery 

Charger 

inactive 

Returns to Green 

Battery Charger Active 

25.

Run Button 



The black “Run” Button (Fig.18-E) is located under the Lamp Cover and serves to initiate the functions as 
described in the following table; 

 Function 

    Action 

Activate 

AGDO 

   Momentary 

press 

Safety Beam override     

Press and hold until garage door is fully closed 

Sleep Mode 

Press and hold in conjunction with “Learn” Button 

26.

Safety Beams 



Genuine 2 wire or aftermarket 4 wire Safety Beams may be connected to the AGDO  



The installation of Safety Beams greatly enhances safety by constantly monitoring for persons or objects 
which may pass within the path of the moving garage door. The AGDO will commence to Safety Reverse if 
the Safety Beams become momentarily or permanently interrupted during a Close Cycle. 

Mounting 



Locate the Safety Beam mounting brackets provided. 



Mark the inside garage door framing so that the bottom edge of the mounting bracket sits 125mm off the 
floor. 



Use the 2 mounting screws provided to fasten each mounting bracket to the wall. 



Use the 2 screws and nuts provided to fasten the Safety Beams to the mounting brackets so that the indicator 
lamp on each Safety Beam is facing upwards. 

Connection 

Genuine 2 Wire 



Using the Figure 8 Cable provided - strip back and connect the 2 strands of one end of the cable to each of 
the 2 terminals located on the outer cover of each Safety Beam. 



Securely fix the cable up and along the wall and run one length of each cable adjacent to the Control Box.  



Strip back and connect one strand of each cable to the Output Terminals “SB2” (Fig.16)