- 25 -
OPTIONS AND FEATURES
28.
Soft Start
When commencing movement from any stationary position the AGDO will slowly ramp up to full speed in
order to minimize start-up load on the AGDO and garage door and provide smooth, quiet operation.
29.
Soft Stop
By intelligently reducing the speed of the garage door as it approaches a limit point the AGDO ensures
quieter garage door closing and enhanced AGDO and garage door life. (Standard function within Adaptive
Mode only)
Adaptive Mode is factory configured to provide soft stopping prior to reaching a limit point. However, for
garage doors that are improperly balanced it may be necessary to disable the soft stop function in order for
the garage door to fully close or fully open
Soft Stop is available only when adaptive mode has been selected
Enabling / Disabling
i.
Remove the Courtesy Lamp and Control Box Covers to expose the Control Board (refer Sec.18 for
removal and replacement details)
ii.
TO ENABLE – select Dip Switch No.7 (SS) to the “ON” position (Fig.16)
iii.
TO DISABLE – select Dip Switch No.7 (SS) to the “OFF” position (Fig.16)
iv.
Replace the Control Box and Courtesy Lamp Covers once selection has been completed.
30.
Speed Control
Running speed may be adjusted within the range of 70 ~ 100% of maximum speed.
Note: Available only when Adaptive Mode has been selected.
Adjustment
To enter Speed Control adjustment mode;
i.
move the Drive Unit so that it is positioned mid way between the 2 Limit Adjust Prongs (Fig.11)
ii.
hinge open the Courtesy Lamp Cover to expose the adjustment controls (Fig.18)
iii.
press and hold the “Learn” Button (Fig. 18-D) for 2 sec in order to initiate Forced Learn – LED
Indicator will begin to quick flash
iv.
rotate the (red) “Speed” Adjustment Pin (Fig.18-F) in a clockwise direction to increase running
speed and anti-clockwise to decrease running speed
v.
Close the Courtesy Lamp Cover once adjustment has been completed
Running speed may only be adjusted while the Drive Unit is traveling between Limit Points.
Speed Control adjustment will close out automatically once the Drive Unit reaches either one of the Limit
Adjust Prongs.
31.
Vacation Mode
During Vacation Mode all functionality is disabled and the AGDO will only function upon receiving a
signal from a pre-learned Hand Transmitter.
Vacation Mode will not function unless at least one Hand Transmitter has been previously learned into the
AGDO.
Entering / Exiting
i.
hinge open the Courtesy Lamp Cover to expose the adjustment controls (Fig.18)
ii.
TO ENTER - press and hold down the “Learn” Button (Fig.18-D) and whilst continuing to hold
down the “Learn” Button press the black “Run” Button. (Fig.18-E)
iii.
TO EXIT - activate the AGDO with one of the pre-learned Hand Transmitters.
Summary of Contents for SDO-21 DP
Page 1: ...1...
Page 2: ...2...
Page 8: ...8 ASSEMBLY INSTRUCTIONS Sectional Track Type Tip Up assembly depicted Fig 3 Fig 3A Fig 3B...
Page 28: ...28 NOTES...
