- 26 -
OPTIONS AND FEATURES
32.
Wall Switch – Hard Wired
A permanently wired Wall Switch may be connected to the AGDO in a convenient location such as adjacent
to a side entry door into the garage.
Connection
Use a normally open momentary contact type switch (similar to spring loaded front door bell type switch)
Use figure 8 cable and connect the wires from the switch to the Output Terminals as depicted in Fig.15
Important Note: The Wall Switch must be mounted within sight of the garage door and a reasonable
distance away from moving parts. It should be mounted at least 1500mm above the ground and the
Entrapment Warning Label provided must be attached adjacent to and within clear sight of it.
33.
Wall Switch – Wireless
The wireless wall switch provides ease of installation without the need for running hard wires to the switch
and is can be mounted in a convenient location such as adjacent to a side entry door into the garage.
Mounting
The switch can be permanently screwed to the wall through the mounting holes provided or alternatively
“hooked” on the wall, providing the convenience of easy demount ability, through the “hook” holes
provided on the base plate.
Use the mounting template and mounting instructions provided with the switch.
The Wireless Wall Switch may be learned into be AGDO as per the procedure outlined on Sec.22 “Code
Learning”
Important Note: The wireless Wall Switch must be mounted within sight of the garage door and a
reasonable distance away from moving parts. It should be mounted at least 1500mm above the
ground and the Entrapment Warning Label provided must be attached adjacent to the switch.
34.
Maintenance
Once every 6 months;
i.
spray the inside of the Drive Rail (Fig.3 Item A) along its entire length with a light coating of
WD40 or silicone spray lubricant.
ii.
disengaged the AGDO from the door (Fig.10) and then test the door to ensure that it meets with the
requirements detailed on Pg.4 Items 3 & 4
TECHNICAL SPECIFICATIONS
INPUT
VOLTAGE:
230 ~ 240VAC 50 ~ 60Hz
OPERATING
VOLTAGE:
24VDC
MAX DOOR HEIGHT:
2440mm using Standard 3174mm rail
MAX
DOOR
WIDTH:
6500mm
MAX DOOR AREA:
14
Square
Meters
MAX LIFTING CAPACITY:
1200N
MOTOR TYPE:
120W
DC
SAFETY OBSTRUCTION FORCE SYSTEM:
Selectable Manual / Adaptive
DOOR TRAVEL ADJUSTMENT:
Manually Adjustable Limit Prongs
RECEIVER CODE STORAGE CAPACITY:
12 Individual Hand Transmitters
TRANSMITTER FREQUENCY:
433.92 MHz Hopping Code
LIGHT GLOBE:
20W 24V Bayonet
DOOR TRAVEL SPEED:
Adjustable ~ 125mm / sec max
AUTO
CLOSE:
Dip Switch Selectable
SAFETY
BEAMS:
Optional
Specifications subject to change without prior notice
Summary of Contents for SDO-21 DP
Page 1: ...1...
Page 2: ...2...
Page 8: ...8 ASSEMBLY INSTRUCTIONS Sectional Track Type Tip Up assembly depicted Fig 3 Fig 3A Fig 3B...
Page 28: ...28 NOTES...
