CHAPTER 5
Instructions, use and maintenance manual
Page 42
D r a g o P 1
5.6. OPERATIONS ON OVEN INSTALLATIONS
This paragraph describes the physical characteristics and setting up procedures of the oven where the machine
will be installed.
The procedure described below can be followed in order to convert a conventional wood-burning oven into an
oven equipped with gas burner.
5.6.1. HOLE IN THE COOKING TOP
The Drago P1 burner is installed in the surface of the oven; the extensions of the torches have to pass through
the oven base, until they reach the level of the cooking surface.
This is done by means of drilling a special hole with diameter of 110 mm and positioned at 50 mm from the inside
wall of the oven.
In the following layout, you can see the area of proper positioning of the hole.
A
C
B
IDEAL POSITION OF THE
HOLE
A
110 mm
B
50 mm
C
100mm
The AVANZINI BRUCIATORI s.r.l. recommended position is the side part, either left or right, at a distance of 100
mm from the central axis; nonetheless, you can position the burner anywhere in the area marked off with a red
dotted line.
The company AVANZINI BRUCIATORI s.r.l. does not authorise any type of installation other than the indicated layout.
The customer is solely responsible for making sure the final installation is in compliance with the requirements in force.
CAUTION!
The machine, having to be used inside a production plant, is not equipped with its own fire-
prevention system. The user must evaluate the need for an adequate fire-prevention system for
the machine/site where the machine is installed and used.
