ASSEMBLY INSTRUCTIONS
11
STEP 10:
Slide the
UPRIGHT SLEEVE(71)
over the
UPRIGHT(11).
Insert the
TENSION CABLE(32)
through the
UPRIGHT(11)
until the
TENSION CABLE(32)
is through and extends out of the square opening
in the side of the
UPRIGHT(11).
Connect the
CONNECTION WIRE(33)
to the
SENSOR WIRE(31).
Slide the
UPRIGHT(11)
onto the
MAIN FRAME(1)
and secure with
BUTTON HEAD BOLTS(M8x1.25x20mm)(49),
LOCK WASHERS(M8)(65),
WASHERS(M8)(61),
and
ARC WASHERS(M8)(58).
Slide down the
UPRIGHT
SLEEVE(71)
to cover the bolt heads.
STEP 11:
Attach the
TRAY(72)
to the
UPRIGHT(11)
with
ROUND HEAD SCREWS(M4x30mm)(55).
STEP 12:
Refer to the inset drawing and the illustration below. To connect the
TENSION KNOB(26)
to
the
TENSION CABLE(32):
1. Set the
TENSION KNOB(26)
at position
“8”,
so the
CABLE END
extends out of the
METAL FITTING
as far as possible. Connect the
CABLE END
of the
TENSION KNOB(26)
to the
HOOK
on the end of the
TENSION CABLE(32).
2. Pull on the Cable of the
TENSION KNOB(26)
firmly
so that enough cable is available to allow the
METAL
FITTING
go through the slot in the top of the
BRACKET.
3. Insert the
METAL FITTING
into the hole at the end of the slot in the
BRACKET.
4. Adjust the
TENSION KNOB(26)
and verify that the
HOOK
moves when the
TENSION KNOB(26)
is
adjusted.
5. Attach the
TENSION KNOB(26)
to the
UPRIGHT(11)
with
ROUND HEAD SCREW(M4x0.7x25mm)(54)
and
WASHER(M4)(63).
Cable End
Hook
Bracket
Metal Fitting
3
2
1
Meijer.com
Summary of Contents for A150-204
Page 24: ...PRODUCT PARTS DRAWING 24 FRONT BACK Meijer com...
Page 28: ...NOTES 28 Meijer com...
Page 29: ...NOTES 29 Meijer com...
