STEP 11
NOTE:
The
RIGHT PEDAL(41)
has
R
stamped on the end of the pedal shaft. The
RIGHT PEDAL(41)
has
right hand threads and is tightened by turning clockwise. The
LEFT PEDAL(39)
has
L
stamped on
the end of the pedal shaft. The
LEFT PEDAL(39)
has left hand threads and is tightened by turning
counterclockwise.
Thread the
RIGHT PEDAL(41)
into the
RIGHT CRANK(37)
located inside the
CRANK COVER(35)
as
shown. Tighten the pedal securely. Select the
RIGHT PEDAL STRAP(42)
which has
R
marked on the
bottom side of the strap. Snap the three hole end onto the inside edge of the
RIGHT PEDAL(41).
Snap the
other end onto the outside edge of the
RIGHT PEDAL(41)
with the
R
mark on the bottom of the
RIGHT
PEDAL STRAP(42).
Select adjustment holes which allow your foot to be easily removed from the pedals.
Repeat on the left side in order to attach the
LEFT PEDAL(39)
to the
LEFT CRANK(36)
and snap the
LEFT
PEDAL STRAP(40)
onto the
LEFT PEDAL(39).
STEP 12
Refer to the inset drawing. Plug the
PULSE SENSOR WIRE(73)
into the socket of
PULSE COIL WIRE(74)
located on the
SEAT CARRIAGE(64).
Plug the
PULSE COIL WIRE(74)
into the socket of
PULSE
CONNECTION WIRE(75)
located on the bracket on the
MAIN FRAME(1).
ASSEMBLY INSTRUCTIONS
10
Socket
Meijer.com
