ASSEMBLY INSTRUCTIONS
7
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove
all packing materials from your area and place them back into the box. Do not dispose of the packing
materials until assembly is completed. Read each step carefully before beginning. If you are missing
a part, please go to staminaproducts.com to the Services section and order the part needed, e-mail
us at customerservice@staminaproducts.com, or call us toll free at 1-800-375-7520 (in the U.S.). Our
Customer Service Staff is available to assist you from 7:30 A.M. to 5:00 P.M. (Central Time) Monday
through Thursday and 8:00 A.M. to 3:00 P.M. (Central Time) on Friday.
R
L
R
NOTE:
Don’t remove or damage the
DECAL(111)
located on the top of the
MAIN FRAME(1).
The
DECAL(111)
is for preventing the
SENSOR WIRE(29)
and the
PULSE CONNECTION WIRE(75)
from dropping into the
MAIN FRAME(1).
STEP 1:
There is an
“R”
decal on one end of the
FRONT STABILIZER(2)
. Attach the
FRONT STABILIZER
(2)
to the
MAIN FRAME(1)
with the
“R”
decal end at right side and secure with
CARRIAGE BOLTS
(M8x1.25x70mm)(81)
and
NYLOCK NUTS(M8x1.25)(104).
STEP 2:
Insert the
STOPPER TUBE(48)
through the
MAIN FRAME(1)
and secure with
BUTTON HEAD
BOLT(M8x1.25x15mm)(94).
NOTE:
The
PEDAL STRAPS(47)
are pre-assembled and attached to the
FOOT PEDALS(46).
The pedal
and strap assembly for the left side has an
“L”
decal. The pedal and strap assembly for the right
side has an
“R”
decal.
STEP 3:
Insert the
PEDAL SHAFT(44)
through the
MAIN FRAME(1).
Place the
RIGHT FOOT
PEDAL ASSEMBLY(46R)
onto the right end of the
PEDAL SHAFT(44)
and place the
LEFT FOOT
PEDAL ASSEMBLY(46L)
onto the left end. Secure the
FOOT PEDALS
with
BUTTON HEAD BOLTS
(M8x1.25x15mm)(94)
and
LARGE WASHERS(M8)(109)
at both ends of the
PEDAL SHAFT(44).
NOTE:
You need to use two Allen Wrenches to tighten the
BUTTON HEAD BOLTS(M8x1.25x15mm)(94)
at both ends of the
PEDAL SHAFT(44)
at the same time.
Meijer.com
