ASSEMBLY INSTRUCTIONS
9
Shoulder
Bracket
STEP 4
Place a
SPACER(61)
on each side of the
SHAFT
on the
UPRIGHT(2).
Slide the
PIVOTING ARMS(71)
onto the
SHAFT
on the
UPRIGHT(2)
on both sides and secure with
SECURING CAPS(49), WASHERS
(ø10xø19x2mm thick)(46),
and
NYLOCK NUTS(M10x1.5)(47).
STEP 5
Slide the lower end of the
PIVOTING ARM(71)
into the bracket on the
PEDAL ARM(9),
and secure with
the
SHOULDER BOLT(ø15.9x77mm, M10x1.5 threaded)(13), WASHER(M10xø21x1.5mm thick)(60),
and
NYLOCK NUT(M10x1.5)(47).
Refer to the Section View. Make sure the shoulder of the
SHOULDER
BOLT(ø15.9x77mm, M10x1.5 threaded)(13)
is fully gone through the holes of the bracket on the
PEDAL
ARM(9)
before tightening the
NYLOCK NUT(M10x1.5)(47).
Repeat to attach the opposite side.
SECTION VIEW
Summary of Contents for A550-090
Page 18: ...PRODUCT PARTS DRAWING BACK FRONT 18...
Page 22: ...NOTES 22...
