Phone lock settings
The handset can be protected from unauthorized use by activating the automatic phone lock. You
can configure one of the following options for automatic phone lock:
•
On
: The handset is automatically locked if it is not used before the specified auto-lock time
expires, or when it is first turned on. The auto-lock time is specified in the
Auto lock time
parameter.
•
On in charger
: The handset is locked immediately when located in the charger.
When removed from the charger and unlocked by the PIN, the handset remains unlocked.
•
Off
: The handset is never locked.
You can change the default phone lock PIN code (“0000”) to a code of your choice. The code
should be of minimum four digits and maximum eight digits.
The
Auto lock time
parameter specifies the time after which the handset is automatically locked.
The shortest value is five seconds and the longest is three minutes.
Note:
If this feature is configured in the
WinPDM
or
Device Manager
, you can call any one of the
five predefined emergency numbers while the handset is locked.
Activating automatic phone lock
Procedure
1. Press
Menu
.
2. Select
Settings
.
3. Select
Locks
>
Phone lock
>
Auto phone lock
.
4. Select one of the following:
•
On
•
On in charger
5. Enter a PIN code of your choice, and then press
OK
.
The code should be of minimum four digits and maximum eight digits.
Note:
If you forget the PIN code, it can be reset by your distributor.
6. Press
Back
.
7. Select
Auto lock time
, and then select the required lock time.
Settings
August 2019
Using 3735 DECT handsets with Communication Manager and IP Office
111
