Switching to a corded headset
Before you begin
You must on a call.
Procedure
To transfer the call to the headset automatically, connect the corded headset.
Operation Notice
Accessibility and voice quality
The connectivity to the communication system is not available. If you cannot connect with your
system, contact your system administrator. For best voice quality, avoid positioning near computer,
radio or similar equipment.
Operating area
You can only use your cordless handset in the area that is covered by your system. Outside this
area, you loose contact with the system. The signal strength icon will be low and
Searching
is
displayed.
Out of Range
When you leave the system's coverage area a short beep will sound and
Searching
is
displayed. The out of range beep is repeated every minute for 30 minutes. The sound can be
turned off by long pressing the
Sound off
(
) key , or
.
When re-entering the coverage area it can take a couple of minutes before the handset
automatically has registered into the system.
Troubleshooting
Problem
Reason
Solution
No headset found
Headset is turned off
Turn on the headset
Headset is out of battery
Charge headset
Headset is out of range
Move the headset closer to the
handset < 10 meters.
Headset is not in pairing mode
Put headset into pairing mode.
Pairing fails
Headset is not in pairing mode
Turn headset into pairing or
discoverable mode.
Table continues…
Operation Notice
August 2019
Using 3735 DECT handsets with Communication Manager and IP Office
51