Telephone settings
191
information about Tones and Cadences on Avaya CS 1000, see Avaya
Features and Services Fundamentals (NN43001-106).
To cause your DECT handset to use the ring cadences configured on
your CS 1000 system, you must activate Cadence Mode on your DECT
handset. This allows the PBX system to control the on and off phases of
the ringing cycles on the handset. If Cadence Mode is disabled on your
handset, the handset continuously plays its ringing melody on any
incoming call, irrespective of the Tones and Cadences configuration on
your CS 1000 system.
To activate Cadence Mode on your handset, perform the following steps:
Attention:
Cadence Mode is applicable to traditional DECT systems
only (based on DMC cards). If you enable or disable
Cadence Mode for a SIP DECT solution, there is no impact.
1.
Open the
Sounds and alerts
menu using the steps
in
“Accessing the Sounds and alerts menu”
(page 177)
.
2.
Press the
Up
or
Down
key to highlight
Cadence
Mode
.
3.
Press the
Select
soft key.
4.
Press the
Up
or
Down
key to select
On
or
Off
.
5.
Press the
Select
soft key to apply the changes.
6.
Press the
Clr
key one or more times to return to the
idle display.
Cadence Mode
Select
On
Off
Select
