FCC Regulations
Pertaining to this equipment
Interference Information (Part 15) Some telephone equipment
generates and uses radio frequency energy, and if not installed and
used properly, may cause interference to radio and television
reception.
Your Lucent Technologies product has been tested and found to meet
the standards for a Class B computing device, as specified in Subpart
J of Part 15 of the FCC Rules. These specifications are designed to
provide protection against such interference in a residential
installation. However, there is no guarantee that interference will not
occur in a particular installation.
If your Lucent Technologies product causes interference to radio or
television reception when in use, you might correct the interference
with any one or all of these measures:
1
Where it can be done safely, reorient the receiving television
or radio antenna.
2
To the extent possible, relocate the television, radio, or
other receiver with respect to the telephone equipment.
3
If your telephone product runs on AC power, plug your
product into an AC outlet that’s not on the same circuit as
one used by your radio or television.
Registration Information (Part 68) The following information is
applicable only to equipment connected directly to the telephone
network and not to connection of stations behind terminal systems.
In compliance with the FCC Rules, you should be aware of the
following:
1
Connection of this equipment to the telephone network must
be through one of the standard network interface jacks.
These jacks may be ordered from the local telephone
company or through Lucent Technologies as your
authorized agent.
2
Registered equipment may not be used with coin telephone
lines or party lines.
3
Customers connecting equipment to the telephone network
will, upon request of the local telephone company, provide
the following information:
