OPERATION
Avaya 9130 EBM Site Preparation, Installation and Operator’s Manual
S
164201770 Rev 1
29
You can clear the alarm by selecting CONTROL and RESET ERROR
STATE from the front panel display. The alarm clears automatically
anytime the UPS is restarted, when a battery disconnection is detected,
or if another battery test is initiated and passed.
Configuring Automatic Restart
The UPS automatically restarts if utility returns after the output was shut
off due to exhausted batteries, a shutdown input signal, or automatic
shutdown command.
You can set the load segment for the amount of time to delay the restart
once utility returns, using the “Automatic Start Delay” setting. You can
also configure UPS restart to depend on the battery charge level, using
the “Battery Charge % to Restart” setting.
Summary of Contents for 9130 EBM
Page 47: ......
Page 48: ...1642017701 164201770 1...
