INSTALLATION
Avaya 9130 1000–3000 VA UPS Site Preparation, Installation and Operator’s Manual
S
164201765 Rev 1
25
1000/1500 VA Models
3000 VA Models
Figure 9. Connecting the UPS Internal Batteries
3.
If you are installing EBMs, see the following section, “Connecting
the EBM(s),” before continuing with the UPS installation.
4.
Replace the UPS right front cover.
To replace the cover, verify that the ribbon cable is protected and (if
EBMs are installed) the EBM cable is routed through the knockout
on the bottom of the cover. Slide the cover to the left until it aligns
with the left front cover. Reinstall the two screws on the right side
of the right front cover.
5.
If your rack has conductors for grounding or bonding of ungrounded
metal parts, connect the ground cable (not supplied) to the ground
bonding screw. See “Rear Panels” on page 76 for the location of
the ground bonding screw for each model.
6.
If an emergency power-off (disconnect) switch is required by local
codes, see “Remote Emergency Power-off” (REPO) on page 53 to
install the REPO switch before powering on the UPS.
7.
Continue to “UPS Initial Startup” on page 29.
