9. Select
Continue
to start the configuration utility.
Important:
Do not change the settings in
Front-end host, System Manager and Certificate
Configuration
without reentering the System Manager enrollment and keystore
passwords before applying the changes.
Warning:
Do not configure the LDAP settings on nodes that you add to a cluster. The LDAP
configuration is automatically configured for additional nodes when they connect to the
initial node.
10. If this is the second node of a cluster and use of virtual IP for internal load balancing is
enabled on the initial node, then do the following:
Important:
The virtual IP must be enabled only for the initial node and the second node. Do not
enable the virtual IP on any other nodes.
a. Select
Clustering Configuration
>
Virtual IP Configuration
.
b. Select
Enable virtual IP
and set the value to
y
(yes).
The system displays additional Virtual IP configuration.
c. Configure all of the Virtual IP settings as described in
on page 91.
Important:
You must use the same Virtual IP authentication password that you set on the
initial node of the cluster.
d. To save the changes on the system, select
Apply
and then select
Continue
.
e. Select
Return to Main Menu
and press
Enter
.
11. To apply the changes, from the main menu, select
Continue
and then select
Yes
to start
the services.
The system starts the services.
12. To exit the configuration tool, select
Continue
.
Next steps
• Set up the required certificates as described in
Certificate configuration using the
on page 148.
• Repeat this procedure to add the required number of nodes to the cluster.
• After all of the required cluster nodes are installed or if new nodes are added to an existing
cluster, you must configure the RSA public and private keys on the initial node.
Related links
Seed node replacement configuration
on page 68
Installing additional nodes to create a cluster
October 2018
Deploying the Avaya Aura
®
Web Gateway
71
