JAO; Reviewed:
SPOC 9/20/2011
Solution & Interoperability Test Lab Application Notes
©2011 Avaya Inc. All Rights Reserved.
10 of 38
ClearOneVH20-SM
Configure the
Trunk Group
form as shown below. This trunk group is used for calls to SIP
endpoints. Set the
Group Type
field to
sip
, set the
Service Type
field to
tie
, specify the
signaling group associated with this trunk group in the
Signaling Group
field, and specify the
Number of Members
supported by this SIP trunk group. Configure the other fields in bold and
accept the default values for the remaining fields.
add trunk-group 50 Page 1 of 21
TRUNK GROUP
Group Number: 50
Group Type: sip
CDR Reports: y
Group Name: To devcon-asm
COR: 1 TN: 1 TAC: 1050
Direction: two-way Outgoing Display? n
Dial Access? n Night Service:
Queue Length: 0
Service Type: tie
Auth Code? n
Member Assignment Method: auto
Signaling Group: 50
Number of Members: 10
On Page 2, verify that the
Preferred Minimum Session Refresh Interval (sec)
field matches
the configuration on Converge Pro VH20 as described in
Section 7
. In this compliance test,
Converge Pro VH20 was configured to match the setting on Communication Manager. That is,
the Min SE Timer on Converge Pro VH20 was set to 180 sec. Alternatively, this timer can be
changed in the trunk group to match the setting on Converge Pro VH20.
add trunk-group 50 Page 2 of 21
Group Type: sip
TRUNK PARAMETERS
Unicode Name: auto
Redirect On OPTIM Failure: 5000
SCCAN? n Digital Loss Group: 18
Preferred Minimum Session Refresh Interval(sec): 90
Disconnect Supervision - In? y Out? y
XOIP Treatment: auto Delay Call Setup When Accessed Via IGAR? n