Additional maintenance procedures
Facility test calls
368
Maintenance Procedures
December 2003
To place a test call
1
Dial the Feature Access Code (FAC) described above and listen for dial tone.
2
S8700
: If the trunk is on an S8700 PN port, dial the 7-digit port location UUCSSpp, where:
•
UU = Cabinet number (01 - 44 for PNs)
•
C = Carrier number (A = 1, B = 2, C = 3, D =4, E = 5)
•
SS = Slot number (01 - 20)
•
pp = Port circuit number (01 - 24)
•
The channels on a DS1 trunk are addressed by using the channel number for the port
number.
3
S8100
: If the trunk is on an S8100 PN port, dial the 6-digit port number
PCSSpp
, where:
•
P =
Port network number (1)
•
C =
Carrier number (A=1, B=2, C=3)
•
SS =
Slot number (01-10)
•
pp = Port number
•
The channels on a DS1 trunk are addressed by using the channel number for the port
number.
4
S8300
/
G700
: If the trunk is on a G700 MM710 Media Module, dial the 7-digit port location
MMMVXyy, where:
•
MMM = Media Gateway number: 3 digits [0 - 9] [0 - 9] [0 - 9]
•
V = Gateway port identifier carrier = 8
•
On a telephone keypad, the number “8” also displays the letters “T”, “U”, and “V”.
•
X = Slot number (1 - 4, if no S8300/LSP in Slot 1)
•
yy = Circuit number
Circuit range depends upon the Media Module on which the trunk is set up. For the Avaya Analog
Media Module (MM711), the range is 1-8; for the Avaya T1/E1 Media Module (MM710), the
range could be 1-23, 1-24, 1-31, or 1-32, depending upon the type of translation and signaling.
Example: If the CO trunk is on port 5, MM in slot 3, of MG 34,
a
Dial FAC.
b
Get dial tone.
c
Dial 0348305.
Summary of Contents for CMC1
Page 1: ...Maintenance Procedures 555 245 103 Issue 1 1 December 2003 ...
Page 14: ...Contents 14 Maintenance Procedures December 2003 ...
Page 416: ...Additional maintenance procedures IP Telephones 416 Maintenance Procedures December 2003 ...
Page 426: ...Index X 426 Maintenance Procedures December 2003 ...
