AVAYA E1/QSIG
9
The above information is provided by AVAYA Inc. as a guide. See disclaimer on page 1
display trunk-group 1 Page 6 of 22
TRUNK GROUP
Administered Members (min/max): 1/29
GROUP MEMBER ASSIGNMENTS Total Administered Members: 29
Port Code Sfx Name Night Sig Grp
1: 01B1701 TN464 F 1
2: 01B1702 TN464 F 1
3: 01B1703 TN464 F 1
4: 01B1704 TN464 F 1
5: 01B1705 TN464 F 1
6: 01B1706 TN464 F 1
7: 01B1707 TN464 F 1
8: 01B1708 TN464 F 1
9: 01B1709 TN464 F 1
10: 01B1710 TN464 F 1
11: 01B1711 TN464 F 1
12: 01B1712 TN464 F 1
13: 01B1713 TN464 F 1
14: 01B1714 TN464 F 1
15: 01B1715 TN464 F 1
display trunk-group 1 Page 7 of 22
TRUNK GROUP
Administered Members (min/max): 1/29
GROUP MEMBER ASSIGNMENTS Total Administered Members: 29
Port Code Sfx Name Night Sig Grp
16: 01B1717 TN464 F 1
17: 01B1718 TN464 F 1
18: 01B1719 TN464 F 1
19: 01B1720 TN464 F 1
20: 01B1721 TN464 F 1
21: 01B1722 TN464 F 1
22: 01B1723 TN464 F 1
23: 01B1724 TN464 F 1
24: 01B1725 TN464 F 1
25: 01B1726 TN464 F 1
26: 01B1727 TN464 F 1
27: 01B1728 TN464 F 1
28: 01B1729 TN464 F 1
29: 01B1730 TN464 F 1
See side
NOTE
There should be 29 total ports for a
single E1 span per MAS.
There should be 59 total ports if
two E1 spans per MAS.
Do not administer (add) the highest
order timeslot/port as a member in
the trunk group.
•
For an MAS with a single E1 card
Do Not add port 30. Only 29 ports
should be in the trunk group.
•
For an MAS equipped with two E1
cards Do Not add Port 60. Only 59
ports should be in the trunk group
.
The reason for this is due to a limitation with
the Dialogic drivers it requires that we leave
out the highest order timeslot to enable MWI,
even though MWI is sent on the D-Channel.
Therefore, only 29 ports are available on an
MAS with one E1 card, or 59 ports on an MAS
with two E1 cards.
Note:
For full N+1 support in your MM environment you should set aside a
number of ports from each MAS in your environment to be allocated for each of
the different port types. When planning trunk group configuration for your
multiple MAS environment care should be taken to ensure the same number of
ports are allocated to the incoming trunk group for each MAS in your
environment. For example, if MAS1 has 16-ports allocated to the incoming trunk
group, MAS2 should also have 16-ports allocated to the incoming trunk group.
When running in a multiple MAS environment with N+1 support, you should
setup the trunks groups as follows: