Enabling SLS
Procedure
To enable SLS on the Branch Gateway, enter
set sls enable
Note:
If you enable SLS and then performed additional administration, you must first
disable SLS and then re-enable it. This causes the SLS application to resynchronize
its administrative database with the Branch Gateway's global CLI command
database.
The Branch Gateway responds with the message,
Survivable Call Engine is
enabled
.
Disabling SLS
About this task
.
Procedure
To disable SLS on the Branch Gateway, enter
set sls disable
The Branch Gateway responds with the message
Survivable Call Engine is
disabled
.
Activating changes in SLS
About this task
To activate changes you make in SLS, use the disable and enable SLS commands together.
To activate changes in SLS, perform the following steps:
Procedure
1. Make any changes to SLS administration desired.
2. While still in SLS mode, enter
set sls disable
The Branch Gateway responds with the message
Survivable Call Engine
is disabled
.
Standard Local Survivability (SLS)
138 Administering Avaya G430 Branch Gateway
October 2013
Summary of Contents for G430
Page 1: ...Administering Avaya G430 Branch Gateway Release 6 3 03 603228 Issue 5 October 2013 ...
Page 12: ...12 Administering Avaya G430 Branch Gateway October 2013 ...
Page 246: ...VoIP QoS 246 Administering Avaya G430 Branch Gateway October 2013 Comments infodev avaya com ...
Page 556: ...IPSec VPN 556 Administering Avaya G430 Branch Gateway October 2013 Comments infodev avaya com ...