Active and configured PMI
If you use the
show pmi
command before you reset the Branch Gateway, two different PMIs
display:
Active PMI:
The IPv4 PMI that the Branch Gateway is currently using, as defined in the running
configuration file.
Configured PMI:
The PMI that the Branch Gateway is configured to use after reset, as defined
in the startup configuration file.
Active PMI6:
The IPv6 PMI that the Branch Gateway is currently using, as defined in the
running configuration file.
PMI configuration CLI commands
For more information about these commands, see the
Avaya Branch Gateway G430 CLI
Reference
.
Root level
command
Command
Description
interface
(fastetherne
t|tunnel|
vlan|
loopback|
dialer)
Enter configuration mode for the
FastEthernet, Tunnel, VLAN,
Loopback, or Dialer interface
pmi
pmi6
pmi6 [link-local]
Set the current interface as the
Primary Management Interface
for the system
Note:
You can define pmi6 or pmi6
link-local on a VLAN interface
only.
You can define pmi and pmi6
simultaneously on the
Gateway, but only on the
same VLAN interface
no pmi
no pmi6
set system
contact
Set the contact information for
this Branch Gateway system
Basic device configuration
66 Administering Avaya G430 Branch Gateway
October 2013
Summary of Contents for G430
Page 1: ...Administering Avaya G430 Branch Gateway Release 6 3 03 603228 Issue 5 October 2013 ...
Page 12: ...12 Administering Avaya G430 Branch Gateway October 2013 ...
Page 246: ...VoIP QoS 246 Administering Avaya G430 Branch Gateway October 2013 Comments infodev avaya com ...
Page 556: ...IPSec VPN 556 Administering Avaya G430 Branch Gateway October 2013 Comments infodev avaya com ...