CLI Commands
ETR
390 Avaya G450 CLI Reference
ETR
set etr
Use the
set etr
command to enable or disable Emergency Transfer Relay (ETR) mode, or to
allow the gateway to control ETR mode automatically.
Note:
Note:
If a call is in progress when the communications problem ends, the gateway does
not turn off ETR mode automatically. If you specify
manual-off
, the call
terminates.
Syntax
set etr
module
{auto | manual-on }
Send-
Flowcontrol-Oper
Send flow-control operation mode. Possible modes:
On — indicates that the local port will send flow control frames
to the far end.
Off — indicates that the local port will
not
send flow control
frames to the far end.
Receive-Flowcontrol-
Admin
Receive flow-control administration. Possible settings:
On — indicates that the local port will act upon flow control
indications if received from the far end.
Off — indicates that the local port will discard flow control
frames if received from the far end.
Receive-Flowcontrol-
Oper
Receive flow-control operation mode. Possible modes:
On — indicates that the local port will act upon flow control
indications received from the far end.
Off — indicates that the local port will discard flow control
frames received from the far end.
Field
Description
2 of 2
Summary of Contents for G450 Manager
