CLI Commands
Routing table configuration
886 Avaya G450 CLI Reference
Related Commands
,
,
ip redirects
Use the
ip redirects
command to enable the sending of redirect messages on the current
interface. Use the
no
form of this command to disable redirect messages. By default, sending of
redirect messages on the interface is enabled.
Syntax
[no] ip redirects
User Level
read-write
Context
interface:Serial (DS1 PPP L2-L3, DS1 PPP L3, DS1 FR-SUB L2-L3, DS1 FR-SUB L3,
USP PPP L2-L3, USP PPP L3), FastEthernet (L2-L3, L3, PPP L2, PPP L2-L3, PPP L3),
Tunnel (L2-L3, L3), VLAN (L2-L3, L3), Dialer (L2, L2-L3, L3)
Related Commands
ip route
Use the
ip route
command to establish a static route. Use the
no
form of this command to
remove a static route.
Syntax
ip route
ip_addr mask
{{
next_hop
[
next_hop
[
next_hop
]] } |
{
interface_type interface_number
}} [
cost
] [
preference
] [permanent |
{track
track-index
} | Null0]
Note:
Note:
You may specify up to three next hops. However, if you apply tracking, you may
only specify one next hop.
Summary of Contents for G450 Manager
