CLI Commands
SLS survivability
1058 Avaya G450 CLI Reference
set send-number
Use the
set send-number
command to define whether or not the calling, connected, called,
or busy party’s administered number is sent to the network on outgoing or incoming calls in
SLS.
Note:
Note:
Leave the setting of
method
to be
no
, since sending a Calling Party Number is a
future feature.
Note:
Note:
This command only applies to ISDN trunks.
Syntax
set send-number
method
Parameters
User Level
read-write
Context
>
Example
To define that the calling, connected, called, or busy party’s administered number is sent to the
network on outgoing or incoming calls:
G450-001 (sls-trunk-group-<tgnum>)# set send-number yes
Parameter
Description
Possible
Values
Default
Value
method
Specifies whether or not the calling, connected,
called, or busy party’s administered number is sent
to the network on outgoing or incoming calls:
●
yes
– The number is sent to the network for
incoming or outgoing calls
●
no
– The number is not sent to the network
for incoming or outgoing calls
●
restricted
– The number is sent to the
network as ’Presentation restricted’
yes
no
restricted
no
Summary of Contents for G450 Manager
