Roadmap
134 Avaya G450 CLI Reference
Spanning tree
interface
{console|dialer|
FastEthernet|
serial|tunnel|
USB-modem}
Enter the context of the Console, Dialer,
FastEthernet, Serial, Tunnel, or USB-modem
interface
Enable or disable Link Up and Link Down traps
on an interface
snmp-server enable
notifications
Enable or disable the sending of all traps and
notifications from the G450
Identify an SNMP management server, and
specify the kind of messages it receives. Use the
no
form of the command to remove the specified
server, or to disable a particular set of notification
types.
Configure the SNMPv3 timeout and retries for
notifications
Table 87: SNMP trap configuration CLI commands (continued)
Root level command
First level command
Description
2 of 2
Table 88: Spanning tree CLI commands
Command
Description
Assign or unassign RSTP edge-port admin state to a port
for Rapid Spanning Tree Protocol (RSTP) treatment
set port point-to-point
admin status
Specify a port’s connection type
Enable or disable spanning tree for specific ports
Set the spanning tree default path cost used by a port
set port spantree
force-protocol-migration
Force the port to send a rapid spanning tree hello packet
(Bridge Protocol Data Unit)
Set the spanning tree priority level of a port
1 of 2
Summary of Contents for G450 Manager
