Issue 1 January 2008
135
SSH protocol
set spantree
default-path-cost
Set the version of the spanning tree default path cost
used by the current bridge
Enable or disable the spanning-tree algorithm for the
media gateway
Specify the time used when transferring the state of a
port to the forwarding state
Specify the time interval between the generation of
configuration BPDUs by the root
Specify the time to keep an information message before
it is discarded
Set the bridge priority for the spanning tree
Set the value in packets used by the spanning tree in
order to limit the maximum number of BPDU’s
transmitted during a hello-time period
Set the version of the spanning tree protocol used by the
device
Display the edge state of a specified port
Display the point-to-point status of a specific port or all
ports
Display spanning-tree information
Table 88: Spanning tree CLI commands (continued)
Command
Description
2 of 2
Table 89: SSH protocol CLI commands
Command
Description
Clear the SSH known-host file content
Generate an SSH host key pair
Disconnect an existing SSH session
1 of 2
Summary of Contents for G450 Manager
